IoT Module Baseboard
[High Resolution Photos]
IoT Module Baseboard

The IoT Module Baseboard, jointly developed by NXP and Embedded Artists, has been designed to provide easy access to the peripherals available on the LPC54018 IoT Module and provides several on-board peripherals for rapid prototyping. The board also includes an on-board debug probe.


Introduction to the LPC54018 IoT Module



Connectors and Interfaces • Arduino UNO compatible expansion connectors (Arduino shield)
• Stereo audio codec with line in/out
• Full speed USB port with micro A/B connector for host or device functionality
• Knowles SPH0641LM4H digital microphone
• Micro SD card slot
• 10/100Mbps Ethernet interface
• 128 Mbit (16 MByte) Winbond SDRAM (x16 databus width)
• TFT LCD (480x272 px resolution) with capacitive touch panel
Debug • On-board, high-speed USB based, LPC-Link2 debug interface with CMSIS-DAP and SEGGER J-Link protocol options for debug of installed IoT module
• UART and SPI port bridging from IoT Module MCU to USB via the on-board debug interface
Other • NXP MMA8652FCR1 accelerometer
• 2x user LEDs
• Target Reset, ISP/User (3) and User buttons
• 2x user LEDs
• Fully supported by MCUXpresso Eclipse-based IDE and GNU C/C++ toolchain
Powering Requires an external +5V supply (on-board 3.3V regulator), with:
• Powering via separate micro-B USB connector (5V), or
• Powering via debug micro-B USB connector
Mechanical 147 x 101 x 24 mm (W x D x H)
Environment Operating Temperature: 15 - 50 degrees Celsius
Operating Humidity: 5 - 90% relative humidity, non-condensing
Product Classification
and Status
Evaluation board; not designed for integration or long time availability

Documentation and Resources

Related Products