iMX6 DualLite Developer's Kit
[High Resolution Photos]
iMX6 DualLite Developer's Kit

Embedded Artists' iMX6 DualLite Developer's Kit lets you get up-and-running quickly with the iMX6 DualLite COM Board. Besides the iMX6 DualLite COM Board the kit contains the COM Carrier Board, which is a carrier board designed for direct integration. All relevant interfaces are available - either for prototyping/evaluation or for direct integration into your product!

The on-board mini-PCIe, SDIO and XBee™ interfaces makes it very simple to add RF solutions.

See Display Solutions for COM boards for details about how easy it is to add a display to your project!

See our EACOM Selection Guide if you need help finding a suitable EACOM board.

 

 

Getting started with iMX Developer's Kit

Getting started with iMX Developer's Kit landing page

 

Specification

The iMX6 DualLite Developer's Kit is an Evaluation product. The individual boards in the kit are Integration products, see respective product page.

COM Carrier Board specification

The information listed below for the COM Carrier Board is valid when the iMX6 DualLite COM board is used. The COM Carrier Board has more interface connectors than listed below, but these interfaces are not supported by the i.MX 6DualLite processor.

Connectors and
Interfaces
• MXM3, 314-pos connector with standoffs for COM boards
• 10/100/1000 Mbps Ethernet RJ45 connector
• USB OTG interface with ESD protection
• Dual USB Host interfaces (via USB Hub) with ESD protection
• HDMI connector with ESD protection
• uSD/MMC connector (MMC is in parallel with uSD, so either one can be used but not both)
• Dual CAN transceivers with ESD protection and optional termination, accessible via Molex Micro-Fit 3.0 connectors
• Internal UART connectors (compatible with FTDI cables)
• XBee™ compatible interface connector
• Mini PCIe connector for half and full-size cards, including SIM card holder and USB interface
• FPC connectors for serial and parallel camera interface and serial display output (MIPI)
• Dual LVDS connectors
• Parallel 24-bit RGB interface for LCD solutions
• Expansion connectors for many COM Board signals
• Audio codec with line out 3.5mm audio jack connector (with internal connector for microphone and line input and headphone output)
Power • 12V (+-30%) supply voltage, either via internal ATX connector or via external Molex Micro-Fit 3.0 connector
• Reverse polarity protection
• Internal 3.3V/4A and 5V/3A (and 3.3V/3A for PCIe) DC/DC converters with high efficiency
• Li-Ion / Li-Polymer battery charger for COM board RTC (note: battery not included)
Dimensions • 165 x 104 mm, same size as typical 7 inch LCDs.
• Five M3 holes for mounting and grounding
Other • On/Off and Reset pushbuttons
• Input current measurement

Included in kit

  • One iMX6 DualLite COM Board (EAC00261)
  • One COM Carrier Board (EAC00246)
  • One Molex Micro-Fit 3.0 2-pos connector with 30 cm cables
  • One Molex Micro-Fit 3.0 10-pos connector with 30 cm cables
  • One micro-B to A USB Cable
  • One FTDI cable (UART-to-USB bridge for console output)
  • One Debug interface board with 10-pos FPC cable
  • Note that battery is not included
  • The included 12V/2A power supply has interchangeable AC plug for EU, UK, US, AUS, KOR and CHN 

Related Products